Apollo 645-062 Manuel d'utilisateur

1APOLLOVacuum Tube Monoblock Power AmplifiersOwner’s ManualRogue Audio, Inc.3 Marian LaneBrodheadsville, PA 18322Issue date: 12/05/08

10LIMITED WARRANTYWarranty PeriodThis product has been manufactured under the highest standards of quality and workmanship. Rogue AudioInc. (hereinaft

2TABLE OF CONTENTS1) Introduction 22) Unpacking the Apollo monoblocks

3INTRODUCTIONCongratulations on your purchase decision! We at Rogue Audio truly believe thatour amplifiers provide the “smartest” value in high-end au

4CONNECTING THE APOLLOS INTO YOUR SYSTEMConnecting Apollo to the Loudspeakers:The rear panel has binding posts for both 4 and 8 ohm loudspeakers. The

5Connecting Apollo to the power outlet:Your Apollo monoblocks have been provided with high ampacity power cords.Use these cords to connect the amplifi

6The triode/ultralinear switch allows the user to operate the Apollos in either of thetwo modes. In general, the sonic differences are subtle but for

7Figure 2. Removable hatchplate1) Allow the amplifier to warm up for at least 15 minutes.2) Turn the preamplifier off so that no signal is entering

86) Make sure that all of the toggle switches are pointed towards the rear of theamplifier. Starting from the left, flip the first toggle switch towa

9OWNER AND WARRANTY REGISTRATION FORMIncluded with this manual is an Owner and Warranty Registration Form. Pleasetake a minute to fill out this card a