Apollo 1550ETL Manuel d'installation télécharger pdf (Page 15)

Adjustments

Push Buttons

TIMER TO CLOSE Adjusts time before gate automatically closes

Adjustable 5 to 70 seconds.

DUAL GATE DELAY Adjusts delay between master and slave op-

eration 0-4 seconds (836 only for use with

magnetic, solenoid, and other locking de

vices)

CURRENT SENSITIVITY Increases or decreases the Auto Reverse

sensitivity.

LED ENABLE When depressed, activates LEDs for 15

minutes to assist in installation and troubleshooting.

Hold the push button down for five seconds to put

the board in program mode.

RESET Resets the microprocessor. Returns processor to

last known state.

OPERATE When depressed, activates the gate. Used for initial

installation and testing.

Hard Shutdown Reset Resets the operator when the gate current

senses twice before fully opening or closing.

Jumpers

STOP CIRCUIT JUMPER When the STOP CIRCUIT

program switch #5 must be ON JUMPER is connected, the gate

will operate normally.

STOP CIRCUIT JUMPER When a 3-button station is con-

program switch #5 must be OFFnected to the board, the STOP

CIRCUIT JUMPER must be re-

moved.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22 23

Pas de commentaire

Apollo 1550ETL Manuel d'installation Page 15