Apollo Intelligent Meter Series IMY Manuel d'utilisateur télécharger pdf (Page 43)

APPENDIX “C” - TROUBLESHOOTING GUIDE

-41-

PROBLEM POSSIBLE CAUSE REMEDIES

NO DISPLAY 1. Power off, improperly connected, or brown-out. 1a. Check wiring.

b. Verify power.

“PPPPPP” IN DISPLAY 1. Program data error. 1. Press “P” and Check data set-ups.

FLASHING DISPLAY 1. Totalizer overflow. 1. Reset totalizer.

“......” IN DISPLAY 1. Loss of data set-ups. 1a. Check data set-ups.

b. Check for electrical disturbance.

c. Disconnect and reconnect power.

DISPLAY WANDERS 1. Loss of data set-ups. 1a. Check data set-ups.

b. Disconnect and reconnect power.

c. Check for electrical disturbance.

JITTERY DISPLAY 1. Electrical “Noise” in process or signal lines.

2. Process inherently unstable.

1a. Increase digital filtering.

b. Increase display rounding increment.

c. Re-route signal wires.

2. Dampen process to eliminate oscillations.

“ULULUL” IN DISPLAY 1. Probe unconnected

2. Broken or burnout probe.

3. Excessive probe temperature.

4. Input overload.

1. Connect probe.

2. Repair or obtain new probe.

3. Reduce temperature.

4. Check input levels.

“OLOLOL” IN DISPLAY 1. Input Underload (negative overload). 1. Check input levels.

“SHort” IN DISPLAY 1. Shorted probe. 1. Check probe.

The majority of all problems with the indicator can be traced to improper

connections or improper programming set-ups. Be sure all connections are clean and

tight and check the programming set-ups for correct data. For further technical

assistance, contact technical support at the appropriate company numbers listed.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48

Pas de commentaire

Apollo Intelligent Meter Series IMY Manuel d'utilisateur Page 43