Apollo Cascade Spécifications télécharger pdf (Page 19)

Troubleshooting Spa Problems

1. Nothing functions: The GFCI Breaker has tripped or there is a power failure. Test GFCI

Breaker. Turn breaker back on and see if spa powers up, if not contact your factory authorized dealer.

2. Spa does not heat: Check to see if the heat indicator is on or there are any error messages on the topside

control panel. If the heat indicator is on and no error message appears contact your factory authorized dealer.

3. Poor Jet Pressure: First check to see that the jet(s) are turned on fully. Check your ﬁlter to see if it’s clogged

or dirty. Next, check to see if the jet(s) are obstructed or if the venturi air dial is turned on. Finally, check to see

if the jet(s) are surging. If so, your pump is cavitating (sucking in air). This usually occurs when the water level

is too low and can be solved by adding water to the spa. Adjust Filter Weir to increase or decrease feed ﬂow. If

the problem still persists, contact your factory authorized dealer.

4. Spa comes on by itself: This function is normal when heating and ﬁltering. No action required.

5. Spa doesn’t drain completely: The spa is drained by gravity. It will not always drain fully. It is not necessary

to drain the spa in its entirety except when winterizing the spa. If you wish to remove the last little bit of water,

we recommend you vacuum it out with a wet/dry vacuum.

1 2 ... 14 15 16 17 18 19 20

Pas de commentaire

Apollo Cascade Spécifications Page 19